Ready to Upgrade Your Kiln Operation? Master These Key Steps Now

Level Installation

• Level the kiln on concrete flooring using supports (2-5cm clearance) and a spirit level
• Ensure three-phase power connection (380V/50Hz or as required) by a certified electrician

Heater Sequence & Water Level

All fans must rotate in the same direction. In manual mode, always start fans before turning on the heating system.

Fill the water tank with clean water until it’s 10–15 cm above the stainless pipe. Never run the system with low or no water.

Wood Loading

✓ Stack wood lengthwise with 2cm spacers between layers

✓ Maintain 30cm clearance at side air ducts for proper hot air circulation

Troubleshooting

• No power? Check emergency stop button first
• Still inactive? Swap two phase lines

Key Reminders

→ Always start fans before heating in manual mode

→ Automatic mode sequences operations correctly

Moisture content before & after drying

Safety meets efficiency—operate your kiln with confidence using these expert guidelines. Get drying now!